EMLID Navio2

EMLID Navio2 Board Autopilot HAT for Raspberry Pi Powered by ArduPilot & ROS

Turn your Raspberry Pi into a UAV controller by harnessing the power of onboard sensors and controllers.

GNSS Receiver - Tracks GPS, GLONASS, Beidou, Galileo, and SBAS satellites. External antenna with MCX connector

Dual IMU - accelerometers, gyroscopes and magnetometers for orientation and motion detection

RC I/O Coprocessor - Accepts PPM/SBUS input and provides 14 PWM output channels for motors and servos

High Resolution Barometer -ndash; Height of the sensors with 10 cm resolution

Interfaces for extensions - Open ADC, I2C and UART interfaces for sensors and radios

Triple redundant power supply - With overvoltage protection and power module connection for voltage and current measurement

product properties

Dimensions: 55 x 65mm
Weight: 23g
Operating temperature: -40 to +85ºC
Operating Voltage: 4.75-5.25V
Power supply: power module, servo rail, USB
Average power consumption: 150mA
Connections: power module, UART, I2C, ADC, 14 PWM servo outputs, PPM/S. bus entrance
ICs: MPU9250 9DOF IMU, LSM9DS1 9DOF IMU, MS5611 barometer, U-blox M8N GLONASS/GPS/Beidou (antenna connector type MCX), Cortex-M3 RC I/O co-processor, RGB LED
scope of delivery

1x Navio2 board
1x connector for RPi
4x spacers
8x M2.5 screws
1x GPS/GNSS antenna for Navio2
1x power module for Navio2
1x cable set for Navio2